If ya wanna fly...

@lovemyjag PAID!!!! Thank you so much! Thanks also to all the retweeters! God bless you!

Aww, man. Anyone know how to fix switches? I don't know where the little piece goes.

For some reason, the red wire was disconnected from the motor and taped back! Reconnected, motor works fine.

Well, it looks correct....time now to plug it in and see if the switch explodes. Mwahahahaaaaaa.......

Front of the blower. The black around the edge is old caulking from previous installation. Harmless.

Need to also clean off the deposits. The whole cooler has that. It's very common bc of Bakersfield's hard tap water.

Belt and pulleys could use some lube but are otherwise in decent condition.

Motor specs. Motor drives the blower by belt.

The pads are a plastic mesh w antifungal/algae/bacteria coating. Still have a bit of life left in 'em.

Pump sends water up through the tubes on top, which then drip water onto the pads on 3 sides.

Green pump doesn't work, he told me that already, Gray pump does work, I plugged it in extension cord & tested it.

Switchbox. Large plug goes to the motor, small plug to the water pump.

The wires to the switch box. No switch, I need to go and buy one.

This is the make/model/voltage/etc. of the cooler.

That far window on the end is the one I can switch the glass with the near window, put the cooler there.

This window would also suit. It's vertical, still pretty close to the end of the trailer. Would prevent the door from...

So, here's another window choice: the bathroom at the end of the trailer. Would be easy to mount there...

...it is 4 feet away from the neighbor's fence. Cooler may fit, but, it pulls air in from 3 sides & that would include

Now. First things first: which window? This is the one I originally had in mind, however...